Use and Care Manual

Step 1
Install the Pole to the Desktop
3
Option A: Weighted Base Install
1. Install the Pole(a) to the Weighted
Base(b) using 3pcs M5x14 Bolts(e), and
tighten using the Allen Key(o), see Figure 1.
2. Optionally, you can drill a 10mm diameter
hole in your desk and secure using the
Support Plate (j), M10 Washer(k), Spring
Washer(l) and M10 Bolt(i). Fasten the M10
Bolt with provided Wrench(p), see Figure 2.
Figure 2
Option B: Grommet Base Install
If the existing grommet hole comes with a
plastic protector, remove it to ensure a flat
surface before installing the desk mount.
1. Install the Grommet Base Plate(m) to the
Pole(a) using 3pcs M5x14 Bolts(e), and
tighten using the Allen Key(o), see Figure 3.
2. Position the Pole(a) on the mounting
surface and secure using the Support Plate
(j), M10 Washer(k), Spring Washer(l) and
M10 Bolt(i). Fasten the M10 Bolt using
provided Wrench(p), see Figure 4.
a
Figure 3
m
e
Figure 4
j
i
k
l
Existing Grommet Hole Installation
a
e
b
Figure 1
j
i
k
l
l