Use and Care Manual

Step 1
Install the Pole to the Desktop
4
Self Drilled Grommet Hole Installation
Option B: Grommet Base Install
1. Position the Pole(a) on the mounting
surface and mark the center hole. Drill a 3/8"
(10mm) diameter hole at the marked position
through the mounting surface.
2. Install the Grommet Base Plate(m) to the
Pole(a) using 3pcs M5x14 Bolts(e), and
tighten using the Allen Key(o), see Figure 5.
3. Position the Pole(a) on the mounting
surface and secure using the Support Plate
(j), M10 Washer(k), Spring Washer(l) and
M10 Bolt(i). Fasten the M10 Bolt using
provided Wrench(p), see Figure 6.
a
Figure 5
m
e
Figure 6
j
i
k
l
Step 2
Install Arm to the Pole
c
o
Install Swivel Arm(c) to the
Pole(a). Fasten the bolt with
supplied Allen Key(o). Attach
the Wire Clip(n1,n2) to the
Pole(a) and Swivel Arm(c).
n1
n2