Use and Care Manual

Step 1
Install the Pole to the Desktop
3
Option B: Grommet Base Install
If the existing grommet hole comes with a
plastic protector, remove it to ensure a flat
surface before installing the desk mount.
1. Install the Grommet Base Plate(m) to the
Pole(a) using 3pcs M5x14 Bolts(f), and
tighten using the Allen Key(o), ssee Figure 3.
2. Position the Pole(a) on the mounting
surface and secure using the Support Plate
(j), M10 Washer(k), Spring Washer(l) and
M10 Bolt(i). Fasten the M10 Bolt using
provided Wrench(p), see Figure 4.
a
Figure 3
m
f
Figure 4
j
i
k
l
Existing Grommet Hole Installation
Option A: Desk Clamp Install
a
1. Install the “C”-Clamp Brace(c) to the Pole
(a) using 3pcs M5x14 Bolts(f), and tighten
using the Allen Key(o), see Figure 1.
2. Install the “C”-Clamp(b) to the pole
assembly according to the thickness of the
desktop. The thickness can be changed to
three positions. Connect it using 2pcs M8x12
Bolts(g), and tighten using the Allen Key(o).
Tighten the “C”-Clamp to the desktop using
the plastic knob, see Figure 2.
Figure 1
c
f
Figure 2
g
o
b
Plastic Knob