User Manual

2012 to current models have a small vacuum pump located between the frame rails.
This pump will need to be relocated.
Step 1: Remove the 2 nuts holding the pump to the bracket and unhook the hoses and wires from the
pump. ( see figure 4 )
Step 2: Using a cutting wheel or a reciprocating saw, remove the front tab of the stock bracket. (see
figure 5 ) Paint the cut edge to prevent rust.
Step 3: Locate the bracket 11 ” from the outside edge of the frame and flush with the bottom of the
cross member. ( see figure 6 ) Layout and drill 3/8 ” holes in the cross member and install the
bracket using the 5/16 x 3/4 ” bolts, nuts, and washers.
Step 4: Install pump into bracket using the 6x30mm bolts and washers provided and the stock nuts
removed in step 1. Reconnect the hoses and wires to the pump.
Step 5: The frame on the 2010 and up models will require some additional cutting. (see figure 8 )
Cut along the line flush with the bottom of the cross member. Paint all cut edges to prevent rust.
You are now ready to install the bumper. Go back to page 2 step 4
This edge to out-
side edge of frame
Figure 4 Figure 5
Figure 6 Figure 7
Figure 8
PAGE 3 of 3
Cut frame here flush with
bottom of frame