DEUTSCH Mountfield M Series Lawnmower Owner’s Manual 8211-0401-01 D
S SVENSKA B 1. 2. 3. 4. D E 5. 6. 7.
S SVENSKA FULL FULL ADD ADD FULL/MAX ADD/MIN 8. Briggs & Stratton 9. Honda 3x 10. Briggs & Stratton 11. Honda G I* B* 12. 13. 14. 15. Left 4 16.
S SVENSKA 17. Briggs & Stratton 18. Honda GCV Briggs & Stratton : 0,76 mm 0,75 mm Honda: 0,7-0,8 mm S S 19. 20. T 40 Nm 21. 23 A. M4, M6 22. S 23 B.
GB ENGLISH SAFETY REGULATIONS SYMBOLS The following symbols can be found on the machine to remind you of the care and attention that are required during use. The symbols mean: Warning! Read the Instruction Book and Safety Manual before using the machine. Warning! Keep onlookers away. Beware of objects being flung out. Warning! Keep hands and feet clear of the cutting deck when the machine is running.
GB ENGLISH • Great care is required when changing direction on a slope. • Do not use the machine on slopes of more than 15°. • Great care is required when reversing or when pulling the mower towards you. • Switch off the engine if the mower must be tilted when being transported over surfaces other than grass, and also when the mower is being transported to and from the area to be cut. • Never operate the mower with inadequate protection or without safety equipment, e.g.
GB ENGLISH • Always seek professional help when the carburettor requires adjustment. • Clean the air filter according to the directions. • When, after many years of service, your machine needs to be replaced or is no longer required, we recommend that the machine is returned to your distributor for recycling. IMPORTANT Equipment which is marked with an asterisk (*) comes as standard in certain models. 3. Then tighten the locking wheels onto the lower part of the handle.
GB ENGLISH To remove the plug, press in the catch (S). On reinstalling the plug ensure that both pins are pressed firmly into the holes so that the plug snaps in place. M2 Combi: To remove the plug, unscrew the wing nut. 2. COLLECTION Assemble the grass collector provided (fig. 4, 6). Open the flap, remove the plug and instead hook the collector onto the rear of the machine. When mowing, the grass is collected in the collector. Empty the grass onto the compost heap or spread it over borders as fertiliser.
GB ENGLISH 4. Set the throttle control B in the choke position . NOTE! It is not necessary to use the choke position when the engine is warm (fig. 12). 5. Press the Start/Stop loop G towards the handle. NOTE! The Start/Stop loop G must be kept pressed in to prevent the engine stopping (fig. 12). 6. Grasp the starter handle and start the engine by pulling briskly on the starter cord. 7. When the engine starts, move the throttle control backwards until max. revs are obtained.
GB ENGLISH COOLING SYSTEM Before each use, the engine’s cooling system must be cleaned. Clean the cylinder’s cooling flanges and air intake of grass remains, dirt, etc. LUBRICATING DRIVE SHAFT (*) Once per season, the wedge on the drive shaft should be greased. Remove the wheel (wheel cap, screw and washer). Then remove the circlip and washer so that the gear wheel can be removed from the shaft. Lubricate the wedge with universal grease.
GB ENGLISH CHANGING BLADES Wear protective gloves when changing blade(s) to avoid cutting yourself. Check the blade system regularly. Check particularly the curved area behind the blade edge for traces of wear. If the blade shows traces of damage it should be replaced. A worn blade creates imbalance and can damage the mower. Always check the blades after a collision. First disconnect the spark plug cable. If the blade system has been damaged, defective parts should be replaced.
ENGLISH 2. Model, type and serial number of the engine: Appears on the engine fan housing as shown: Briggs & Stratton GB al laws. The rights to which the purchaser is entitled with the support of these laws are not restricted by this guarantee. Honda Use this identification whenever you contact a service workshop or buy replacement parts. As soon as possible after buying the machine, write the above numbers on the back page of this booklet.
EC conformity declaration 1.Category Lawnmower with petrol engine 8.Make Mountfield 2.Type E431, E481, E531 9.Cutting width 1-2. 3-4. 5. 3.Item no 1. 12-1581, 2. 12-1681, 3. 12-5503, 4. 12-5603, 5. 12-9604 4.Manufacturer STIGA Produktion AB P.O. Box 1006 SE-573 28 Tranås Sweden 5.Vibration 10.Serial number 43 cm 48 cm 53 cm See label on chassis 11. Engine 2 1-2. 9,0 m/s 3-5. 8,0 m/s2 Make 1-2. Briggs & Stratton 3-5. Honda Model 1-2. LS 45 3-4. GCV 135 5. GCV 160 STOP (ISO 5349) 1-4.
M a n u f a c t u r e d b y St i g a A B , S w e d e n w w w. s t i g a .