User's Manual

26
MULTI-USER operation
1. Multi watches tracking
All devices must be paired together to be able to run into the MULTI-USER mode (see the «Pairing procedure:
pair your devices (robots, watches and beacons)», page 24).
TurnOFFallwatches.FollowthePIXIOsetupprocedure,untilthebeginningofthetracking(page8).The
PIXIOrobotstartstotracktherstwatchON.
Oncethetrackingbegins,turnONtheadditionalwatchesbypressingthe
button.Thegreen light of
eachwatchstartstoblink.Theblinkingisslowifthereisnoremotecontrolconnectedtothedevice.
The robot will lm the last watch turned on. You can switch from one watch to
another using Pixio Remote Control app. on your phone while lming (see page 14).
Ifthereisnoremotecontrolconnected,pressthe
buttonofawatchtobetrackedandlmed.The
light is full greenwhenthewatchislmed.Stoprecordingbypressingthe
buttonagain.Thegreen light
asheswhenthecameraisnotrecording.
LightOFF,
watch OFF
Blinkinglight,
watchON/recordOFF
LightON,
WatchON
RecordON