User's Manual

31
2. Start the UPGRADE mode
PressandholdTurnRightbuttonontherobot,thenbrieypressonpowerbutton.
Release TurnRightbuttonwhentheredlightstartstoblink.
3. UPGRADE each device
Next,youhavetoupgradeeachelementoneaftertheother(notall
atthesametime):
For the robot:PressbrieyTurnLeftbutton.ThegreenLEDblinksrapidlyduringtheupgrade,andstopswhen
itisnished.
For a watch or a beacon (switched OFF before the procedure):
 →Startthe«upgrade»mode:pressitsstartedbuttonduringseveralseconds,untilitsgreenLEDblinks
 →Releasethebutton,andpressitagainbrieytolaunchtheupgrade.ThegreenLEDblinksrapidly
duringtheupgrade,andturnsfullgreenwhenitisnished.
1.Pressonhold
turnRIGHTbutton
3.ReleaseturnRIGHT
buttonwhenthered
lightstartstoblink
2.BrieflypressPOWER
ON
4.PressturnLEFT
buttontoupgrade
therobot
Is there a problem? Don’t panic....
►Iftheupgradeisaborted(error,switchOFF,…),youcanstartagaintheprocedure.
Ifduringstep2,theredLEDdoesnotblink:
►Checkthatthemicro-SDcardcapacityislowerthan32GbandformattedwiththeFAT32,FAT16,orFAT12
format;
►Checkthattheupgradeleisstoredattherootofthecardandnotinasub-directory;
►Checkthatthecardisinsertedcorrectlyintherobotslot.