User's Manual

13
Start tracking
AdjustthetripodhorizontallyandsettheTILTangleofthecamerabyscrewingmoreorlessthescrewattherear
oftherobot.
By rotating the tripod, or using robot buttons an d ,placethebeaconn°1atthecenterofthescreen.
Theimportantpointistheleft-rightpositioning(nottheup/downposition).UsetheZOOMcursoronthetopofthe
MOVE‘NAPPtoimprovetheaccuracy.A50cm(20inches)accuracyisenough.
SwitchONthewatchbypressingitsstarterbutton until the green light turns ON. The system initializes
duringabout10to30seconds.WhenthewatchLEDisblinkingregularly,theinitialisationisnishedandtherobot
istrackingthewatch.
Beacon n°1
ZOOM cursor
unscrew to
decrease
the TILT angle
screw to
increase the
TILT angle