User's Manual

41
TRACKING
PROBLEM CAUSE SOLUTION
The PIXEM robot always films on my side�
The beacon n°1 was not well at the center
of the frame before starting the watch, and/
or the beacon n°1 was much closer to the
camera than the whole area you want to film,
and/or the robot is not screwed enough to the
tripod
1� Re-start the system, checking that the
beacon n°1 is well at the center (right-left) of
the camera screen before starting the watch�
Check that the distance between the beacon
n°1 and the camera is similar to the maximum
distance of the area you want to film (half this
distance is a minimum)�
2� Check that the robot is well screwed to the
tripod�
ZOOM / REC
PROBLEM CAUSE SOLUTION
I cannot start recording from the watch and
the zoom is fixed
The app is not connected to the robot
1� activate the bluetooth on your smartphone
or tablet
2� launch the MOVE ‘N APP
3. turn the robot ON then briey press the
button on the rear of the robot�
RECHARGE
PROBLEM CAUSE SOLUTION
The watch does not recharge (the red LED is
OFF)
The watch battery is already charged
or
The watch is not properly placed on the
charger
1� Check that the watch is not already charged�
2� Check that the watch is positioned on the
right side of the charge (the side without
marks)�
3� Check that the watch is in direct contact
with the charger�
The robot or a beacon does not recharge (the
red LED is OFF)
The battery device is already charged
Check that the device is not already charged
(the red LED does not turn ON if the battery is
charged)�