User's Manual

3
charge, the LED Indicator light on the mouse will blink intermittently
when in use. To optimize the performance of your NiMH battery, it is
best to recharge it after every day of use.
If a full charge is not required, you can remove the mouse from the
charging cradle at anytime. You do not need to wait for the LED Indicator
light to stop flashing.
To conserve power, the mouse enters a “Sleep Mode” when it is left on
for more than 24 hours. To awake from Sleep Mode, click any button.
Using the In-Line Battery Charger (select models only)
The In-Line Battery Charger is included with the Professional model only.
To charge the NiMH battery pack using the in-line battery charger:
1. Connect the power adapter to the in-line battery charger and plug it into
a power source.
2. Place the battery pack in the charger and the LED Indicator light will turn
solid blue.
3. To eliminate the need of one additional adapter, install the smaller
connector of the charger cable into the back of the in-line charger and
install the larger connector into the front of the charging cradle.
Installing and Charging the Batteries
Important: The GO 2.4 GHz Optical Air Mouse must be charged for nine (9) hours prior
to its first use.
The GO 2.4 GHz Optical Air Mouse comes with a NiMH battery pack already
installed, but you will need to remove the plastic tab located inside the
battery compartment. This clear plastic tab prevents the battery from
discharging until you are ready to use your mouse. To remove the tab and
charge your batteries:
1. Press the Battery Release button at the bottom of the mouse and slide
the NiMH battery pack off.
2. Remove and discard the plastic tab.
3. Replace the battery pack by sliding it into place on the mouse.
4. Connect the power adapter to the charging cradle and plug it into
a power source.
5. Place the mouse in the charging cradle. The cradle’s LED Indicator light,
located at the back of the cradle, will turn solid blue and the LED
Indicator light on the mouse will faintly flash green while its batteries
are charging.
6. Once the batteries are fully charged, the LED Indicator light on the
mouse will maintain a steady glow and will be ready for use.
Battery Tips
For optimal battery life, avoid using the mouse on dark-colored surfaces.
When the battery drops to approximately twenty percent (20%) of its full
2
GC1005M_NA_IB_REVA_K6.qxd 2/11/05 11:33 AM Page 2