MOVING. Spot Cooling Systems INSTRUCTION MANUAL MODEL : 10SFU 108FU-1 READ THIS MANUAL CAREFULLY FOR INSTRUCTIONS ON CORRECT INSTALLATION AND¥ USAGE, AND: READ ALL SAFEGUARDS.
1. PART NAMES Model 10SFU] Imbecile 108FU-1] COOLING AR DUCT HOT AIR OUTLET S CONTROL SWITCH AR FILTER / {CONDENSER AIR INTAKE] AR FILTER (EVAPORATOR AR INTAKE) DRAIN TANK COOLING AIR DUCT HOT AIR OUTLET = CONTROL, SWITCH o THERMOSTAT DIAL AR FILTER {CONDENSER.
2. ASSEMBLY 2-1; Air duets Using ford screws, install cooling gir duct to the wit 2:2.
3 IMPORTANT SAFEGUARDS Read ‘the following safeguards carefully ‘when installing ‘the unit. This manual should be saved for future reference. not install and operate the unit in potentially explosive or combustible atmosphere. Do ‘Aot operate the unit 1o an atmospherics of Corrosive Gases The ‘environmental requirements of this unit &1 the [installation site are: 25'C {ITF] to 40C (104°F) with: a B0% relative humidity when: the unit s in operation.
4. INSTRUCTIONS FOR USE 41, Control switch: panel The operation: of: the unit is controlled by the switch above the panel, Check the power supply before turning the unit on. {FaN! FAN e Thai fan will start when the switch is senorita FAN, Off «Coyly [cool] T start cooling.. set the switch 10 COOL: [OFF] Bet the ‘switch to off, and the Tan .and doodler will stop: Fig: 4-1. Control switch panel NOTE: 1 2) 3 When the overflow: lamp lights;, the drain tank.
4} TEMPERATURE CONTROL {108FU-1 only) The compressor 1§ controlled by a thermostat ‘which senses the return aif temperature, Whig thermostat can be set to proximate temperatures by means of ‘the thermostat dial, educated below the control switch. Dial Setting Return: Air Superstore | C |32 129 {(Approx) 190 Fig. 4-2. Thermostat dial Windshield thug unit i§ continuously operated with the: dial set t0. 5 oF more, the compressor will ‘occasionally’ stop 1o avoid freezing. 4-2.
5. OPERATION SAFEGUARDS 11 Q Once: the unit Has been switched off, ‘wail ‘three: minutes be: fore ‘restarting: the unit 1w protect ‘the: compressor. (MISRULE WAITS MINUTES) only} 21 Do not wrn the switch roughly DOWNTURN or unnecessarily. ROUGHLY. 3} DO hbE move the it While e DONOR MOVE WHILE RUNNING: fan or cooler I8 running.
4l 8] 8 Connect the power cable. firmly into the socket, Disconnect the power-cable by pulling the plug; Hot on wire. Connect plug 1o the: proper power Source: 115 volts, Dig Aot wingding our Hand or any other object Into’ the duets: Close ‘supervision is. necessary whine the dint s used near child eat and pets Do into ‘block the: air filters. PULL PLUG DONATELLO POWER WIRE DO NOT INSERT ANY OBJECT. 00 NOT BLOCK AR FILTERS.
7} Do vot taus the Unit with wet DO NOT TOUCH ot dirty hands, BY WET OR CITY HANDS, aor Y oF overrun the stapler. DOTINGLY Never put’ anything on top of OR OVERTURN. W S the unit 8) If water: ghouls leak from the unit, tur the switch to-the: OFF position,. and drain the water from’ the tank.
8. INSPECTION AND CARE OF THE UNIT Reed the following instructions on the ‘crag and inspection of the unit carefully 1o Help insure the hostess “ih cooling comfort Care of unit incidences the following: Daily inspection Preseason inaction Scald be carried Gut befall putting the unit into season; Off season inspection -« Unit should be completely checked out before storing away for the season. 6-1. Dally and in-season inspection A, Check! air filters At least once a week:or: every two.
7. HINTS FOR ENJOYING THE SPOT COOLING SYSTEM In contest o roost conventional coolers, which circulate cool air to the entire environment, this wit s designed for cooling particular areas or objects: To cool: the areas desired simply turn the cooling .air ducts in that direction. The unit 1§ particularly effective for providing ‘spat cooling for workers With large: ‘open spices. 8.
