Operation Manual
Table Of Contents
- SERIAL NUMBER LOCATION
- TABLE OF CONTENTS
- SAFETY PRECAUTIONS
- NAMES OF PARTS
- NOZZLES
- CONTROL PANEL
- INSTALLATION
- INITIAL SETTINGS
- OPERATION
- COOL MODE
- FAN ONLY MODE
- SCHEDULE MODE
- STARTING SCHEDULE MODE OPERATION
- STOPPING SCHEDULE MODE OPERATION
- TEMPORARY STOP DURING SCHEDULE MODE
- SETTING / EDITING / VIEWING SCHEDULE
- CLEARING SCHEDULE
- ADJUSTING BRIGHTNESS
- FAN MODE
- CHANGING TEMPERATURE SCALE
- KEY LOCK
- KEY UNLOCK
- TEMPORARY STOP DURING KEY LOCK
- SERVICE INFORMATION
- SELF-DIAGNOSTIC CODES
- LIST OF SELF-DIAGNOSTIC CODES
- EMPTYING THE DRAIN TANK
- CONDENSATE PUMP KIT (OPTIONAL ACCESSORY)
- MAINTENANCE
- TECHNICAL SPECIFICATIONS
- TROUBLESHOOTING
- WARRANTY STATEMENT
- DATA PRIVACY DISCLOSURE
33
5. Insert the alarm signal wires through the hole in the rear panel and then through the hole in
the control box.
Recommended wire size: 16 AWG - 22 AWG
EXTERNAL ALARM DEVICE CONNECTION
Hole in the Rear Panel
Route of Signal Wires
Terminal Block
Hole in the Control Box
OS-1
OS-2
FA-2
FA-1
AL-1
AL-2
Alarm Device 1
Alarm Device 2
Terminal Block
6. Connect the alarm signal wires to terminal AL-1 and AL-2 and/or FA-1 and FA-2 as shown
in the figure.
7. Reinstall the panels.