User's Manual

BluePin II V10M10_IM_EN_10302007
www.i-Luv.com
- 4 -
communications, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority
to operate the equipment. Refer to 47 CFR Sec. 15.21.
Industry Canada Notice to Canadian Users
Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation of the device. Refer to IC RSS 210 Sec. 5.11. The term “IC”
before the certification or registration number only means that the
registration was performed based on a Declaration of Conformity and
that Industry Canada technical specifications were met. It does not
imply that Industry Canada (IC) approved this equipment. Refer to
Self-Marking 6(f) and RSP 100 Sec. 4.
USER SAFETY GUIDE
Additional Safety Instructions
• When not in use, keep your device in a safe place where it will not
be bent or crushed.