User`s manual

IA260-261-262 EM-2260 LX User’s Manual Getting Started

Powering on the IA260/IA261/IA262/EM-2260

Connect the SG wire to the shielded contact located in the upper left corner of the

IA260/IA261/IA262/EM-2260, and then power on the computer by connecting it to the power

adaptor. It takes about 60 seconds for the system to boot up. Once the system is ready, the Ready

LED will light up.

NOTE After connecting the IA260/IA261/IA262/EM-2260 to the power supply, it will take about 60

seconds for the operating system to boot up. The green Ready LED will not turn on until the

operating system is ready.

ATTENTION

This product is intended to be supplied by a Listed Power Unit and output marked with “LPS”

and rated 12-48 VDC, 580 mA (minimum requirements).

Connecting the IA260/IA261/IA262/EM-2260 to a PC

There are two ways to connect the IA260/IA261/IA262/EM-2260 to a PC: through the serial

console port or via Telnet over the network. Or, you can use a monitor connected to the VGA

output of the IA260/IA261/IA262/EM-2260 to connect directly to the computer.

Debug Port

The debug port gives users a convenient way of connecting to IA260/IA261/IA262/EM-2260. This

method is particularly useful when using the computer for the first time. Debug port is useful for

connecting IA260/IA261/IA262/EM-2260, so you do not need to know either of its two IP

addresses in order to connect to the debug port.

Use the debug port settings shown below.

Baudrate

115200 bps

Parity

None

Data bits

Stop bits:

Flow Control

None

Terminal

VT100

2-2