User`s manual

3-4 Intellio C218Turbo /PCI User's Manual
You have to set up all the ports of the board with the desired “COM number”,
which should not conflict with other COM number in use. In this “Individual Port
Setting” dialog box, you may have two ways to map the physical ports to COM
numbers depending on the check box “Auto Enumerating COM number”.
 Sequential Port Mapping: (Enable “Auto Enumerating COM number”)
Specify the COM number of the first port and subsequent ports are mapped to
continuous COM numbers. For instance, if first port is mapped to COM10, then
second port is mapped to COM11 sequentially.
 Non-sequential Port Mapping: (Disable “Auto Enumerating COM number”)
Specify the COM number for individual port. For instance, the second port can
be out of sequence, say COM18, while the first port is mapped to COM10.
In “Individual Port Setting” dialog, you may click on [Advanced Setting] button
to tune the advanced features, “UART FIFO” and “Transmission Mode”, for
each port for particular performance requirements.
Note ! You may skip the following settings and go to the next step 8 if you
do not require any particular performance tuning for the driver.