User's Manual

Installing MOXA EtherDevice Switch
MOXA EtherDevice Switch Hardware Installation Guide
3
-
3
You should also pay attention to the following items :
??Use separate paths to route wiring for power and devices. If power wiring and
device wiring paths must cross, make sure the wires are perpendicular at the
intersection point.
??NOTE: Do not run signal or communications wiring and power wiring in the
same wire conduit. To avoid interference, wires with different signal
characteristics should be routed separately.
??You can use the type of signal transmitted through a wire to determine which
wires should be kept separate. The rule of thumb is that wiring that shares
similar electrical characteristics can be bundled together.
??Keep input wiring and output wiring separated.
??It is strongly advised that you label wiring to all devices in the system when
necessary.
Grounding MOXA EDS-508
Grounding and wire routing help limit the effects of noise due to electromagnetic
interference (EMI). Run the ground connection from the ground screw to the
grounding surface prior to connecting devices.
This product is intended to be mounted to a well-
grounded mounting
surface such as a metal panel.