User manual

Test Report ------------------------------------------------------------------------------- 7/48
Report No.: M47ET060805 (ETSI EN 301 489)
Training Research Co., Ltd., TEL: [phone], Fax: [phone]
Test Method
1. The DC-In connected to AC mains supply by switching adapter.
2. The two USB ports connected with USB flash drive.
3. The Relay Output port connected with terminator.
4. The LAN port of EUT connected to far LAN card.
5. The four RS-232/422/485 ports connected with terminators.
6. The notebook PC and test fixture is connected by USB transfer to RS-232 cable, and
then test fixture connected with EUT setting test mode.
7. Using the PC and software provided by the manufacturer to control EUT, the test is
performed under the specific conditions.
8. Then making EUT to the following mode.
(a) EMI testing: making EUT to linking mode with support equipments
(b) EMS testing: same as above