User's Manual

NOTE If you are using an Ethernet-to-USB adapter, follow the
instructions in the user’s manual provided with the adapter.
• Step 3: Set up the computer’s IP address
Choose an IP address for the computer that is on the same subnet as the
AWK. Since the AWK’s default IP address is 192.168.127.253, and the
subnet mask is 255.255.255.0, set the IP address to
192.168.127.xxx, where xxx is a value between 1 and 252.
• Step 4: Access the homepage of the AWK.
Open your computer’s web browser and type
http://192.168.127.253 in the address field to access the AWK’s
homepage. Log in using the following default username and
password:
Default Username: admin
Default Password: moxa
Click the Login button to access the homepage of the AWK device.
First-Time Quick Configuration
After successfully accessing the AWK, refer to the appropriate
subsection below to quickly set up a wireless network.
NOTE Ensure that there are no IP address conflicts when you
configure more than one AWK on the same subnet.
Point-to-Multipoint Scenario (AP/Client Mode)
Configuring the AWK as an AP
• Step 1: Set the operation mode of the AWK to AP mode. Go to
Wireless LAN Setup  Operation Mode and select AP.
NOTE The default operation mode for the AWK is AP.
- 17 -