User's Manual

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-Consult the dealer or an experienced radio/ TV technician for help.

CAUTION:

Any changes or modifications not expressly approved by the grantee of this device

could void the user's authority to operate the equipment.

RF exposure warning

This equipment must be installed and operated in accordance with provided

instructions and the antenna(s) used for this transmitter must be installed to provide

a separation distance of at least 20 cm from all persons and must not be co-located

or operating in conjunction with any other antenna or transmitter. End-users and

installers must be provide with antenna installation instructions and transmitter

operating conditions for satisfying RF exposure compliance.

This radio transmitter FCCID: SLE-1137C has been approved by FCC to operate with the

antenna types listed below with the maximum permissible gain and required antenna

impedance for each antenna type indicated. Antenna types not included in this list,

having a gain greater than the maximum gain indicated for that type, are strictly

prohibited for use with this device.

Antenna List

No.

Company

Part No.

Antenna Type

Peak Gain

Moxa ANT-WDB-ARM-0202

Omni

directional

Antenna

1.8dBi for 2.4 GHz

1.8dBi for 5.150-5.250 GHz

1.6dBi for 5.250-5.350 GHz

1.8dBi for 5.470-5.725 GHz

1.8dBi For 5.725~5.850GHz

Note: The antenna connector is Reverse SMA type