User's Manual

STEP 1:
Remove the aluminum
DIN-rail attachment
plate from the
AWK-1137C, and then
attach the
wall-mounting plates
with M3 screws, as
shown in the adjacent
diagrams.
STEP 2:
Mounting the AWK-1137C to a wall requires 2 screws.
Use the AWK-1137C device, with wall-mounting
plates attached, as a guide to mark the correct
locations of the 2 screws. The heads of the screws
should be less than 6.0 mm in diameter, and the
shafts should be less than 3.5 mm in diameter, as
shown in the figure on the right.
Do not drive the screws in all the way—leave a space of about 2 mm to
allow room for sliding the wall-mounting panel between the wall and
the screws.
NOTE Test the screw head and shank size by inserting the screws into
one of the keyhole shaped apertures of the wall-mounting
plates before they are fixed to the wall.
STEP 3a:
Once the screws are fixed into the
wall, insert the two screw heads
through the large opening of the
keyhole-shaped apertures, and then
slide the AWK-1137C downwards, as
indicated to the right. Tighten the
two screws for added stability.
STEP 3b:
Alternatively, insert four screws
directly through the AWK-1137C
into the wall.
- 7 -