MGate 5134 Series Quick Installation Guide Version 1.0, September 2022 Technical Support Contact Information www.moxa.com/support 2022 Moxa Inc. All rights reserved.
Overview The MGate 5134 is an industrial Ethernet gateway for Modbus RTU/ASCII/TCP and PROFINET network communications. Package Checklist Before installing the MGate 5134, verify that the package contains the following items: • • • 1 MGate 5134 gateway Quick installation guide (printed) Warranty card NOTE Please notify your sales representative if any of the above items is missing or damaged.
LED Color Green ETH 1, ETH 2 Amber Off Description 3. Timeout (the slave device does not respond). 4. TCP connection failed (only for Modbus TCP). Steady ON: Ethernet link on at 100Mbps. Blinking: Data transmitting at 100Mbps. Steady ON: Ethernet link on at 10Mbps. Blinking: Data transmitting at 10Mbps. Link is down or not connected.
The following figure illustrates the two mounting options: Wall- or Cabinet-mounting We provide two metal plates to mount the unit on a wall or inside a cabinet. Attach the plates to the unit’s rear panel with screws. With the plates attached, use screws to mount the unit on the wall. The heads of the screws should be 5 to 7 mm in diameter, the shafts should be 3 to 4 mm in diameter, and the length of the screws should be over 10.5 mm.
Ethernet Port (RJ45) Pin 1 2 3 6 Signal Tx+ TxRx+ Rx- Power Input and Relay Output Pinouts V2+ V2- DC Power Input 2 DC Power Input 2 N.O. Common N.C. V1+ V1- DC Power Input 1 DC Power Input 1 Specifications Power Parameters Power Input Power Consumption Relays Contact Current Rating Environmental Limits Operating Temperature Storage Temperature (package included) Ambient Relative Humidity Physical Characteristics Dimensions Weight Reliability Alert Tools MTBF 12 to 48 VDC 455 mA max.
ATTENTION • • • NOTE • • This device is an open-type equipment and intended to be installed in a suitable enclosure. If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be impaired. When installing the device, the assembler is responsible for the securing the safety of the system in which the equipment is incorporated. This device is intended for use indoors and at altitudes up to 2,000 meters. Pollution degree 2.
