Installation Guide

- 6 -
STEP 3:
Once the screws are fixed into the wall, insert the screw heads through
the large opening of the keyhole-shaped apertures, and then slide the
AWK-1151C downwards, as indicated to the right. Tighten the screws
for added stability.
WARNING
•
This equipment is intended to be used in a Restricted
Access Location, such as an enclosed machine cabinet or
chassis where only authorized service personnel or users
can gain access. Such personnel must be instructed about
the fact that the metal chassis of the equipment can be
extremely hot and may cause burns.
•
Service personnel or users have to pay special attention
and take special precautions before handling this
equipment.
•
Only authorized, well-trained professionals should be
allowed to access the restricted access location. Access
should be controlled by the authority responsible for the
location with lock and key or a security identity system.
•
External metal parts are hot!! Pay special attention or
use special protection before handling the equipment.
Wiring Requirements
WARNING
Safety First!
Be sure to disconnect the power cord before installing and/or
wiring your
AWK-1151C.
Calculate the maximum possible current in each power wire and
common wire. Observe all electrical codes that dictate the
maximum current allowed for each wire size. If
the current
goes above the maximum ratings, the wiring could overheat,
causing serious damage to your equipment.