User's Manual

AirWorks AWK-4121 User’s Manual Web Console Configuration
Auto Warning Settings
Since industrial-grade devices are often located at the endpoints of a system, these devices will
not always know what is happening elsewhere on the network. This means that these devices,
including wireless APs or clients, must provide system maintainers with real-time alarm
messages. Even when system administrators are out of the control room for an extended period,
they can still be informed of the status of devices almost instantaneously when exceptions
occur.
In addition to logging these events, the AWK-4121 supports different approaches to warn
engineers automatically, such as SNMP trap, e-mail, and relay output. It also supports two
digital inputs to integrate sensors into your system to automate alarms by email and relay
output.
System Log
System Log Event Types
Detail information for grouped events is shown in the following table. You can check the box for
Enable log to enable the grouped events. All default values are enabled (checked). The log for
system events can be seen in Status > System Log.
System-related events Event is triggered when…
System restart (warm start)
The AWK-4121 is rebooted, such as when its settings
are changed (IP address, subnet mask, etc.).
Network-related events Event is triggered when…
LAN link on The LAN port is connected to a device or network.
LAN link off
The port is disconnected (e.g., the cable is pulled out,
or the opposing device shuts down).
Client joined/ left
(for AP mode)
A wireless client is associated or disassociated.
WLAN connected to AP
(for Client mode)
The AWK-4121 is associated with an AP.
WLAN disconnected
(for Client mode)
The AWK-4121 is disassociated from an AP.
Config-related events Event is triggered when…
Configuration Changed A configuration item has been changed.
Configuration file import via Web
Console
The configuration file is imported to the AWK-4121.
Console authentication failure An incorrect password is entered.
Firmware upgraded The AWK-4121’s firmware is updated.
3-31