User's Manual

AirWorks AWK-4121 User’s Manual Introduction
Functional Design
LED Indicators
The LEDs on the front panel of AWK-4121 allow you to identity the status and wireless settings
quickly.
The LED for FAULT indicates the system failure and
user-configured events. If the AWK-4121
cannot retrieve the IP address from a DHCP server, the FAULT LED will blink at an interval of
one second.
The following table is a summary for the wireless settings and LED displays. You can check the
status of the AWK-4121 by reading these LEDs. More information about “Basic Wireless
Settings” is presented in Chapter 3.
LED Color State Description
On
Power is being supplied (from power input 1 or 2,
or PoE).
PWR
Green
Off Power is not being supplied
On
Relay is event-triggered.
Blink (slow)
Cannot get an IP address from the DHCP server
(interval: 1 sec)
Blink (fast) IP address conflict (interval: 0.5 sec)
FAULT
Red
Off Normal status
Green Software Ready
Green Blink
The AWK Search Utility has located the AWK.
(interval: 1sec)
STATE
Green/Red
Red Booting or Error condition
Green On WLAN functions in Client mode.
Green Blink
WLAN’s data communication is run in Client
mode
Amber On WLAN functions in AP/Bridge mode.
Amber Blink
WLAN’s data communication is run in AP/Bridge
mode
WLAN
Green/Amber
Off WLAN is not in use or not working properly.
Yellow On LAN port’s 10Mbps link is active.
Yellow Blink Data is being transmitted at 10 Mbps
Yellow Off LAN port’s 10Mbps link is inactive.
Green On LAN port’s 100Mbps link is active.
Green Blink Data is being transmitted at 100 Mbps
LAN
Yellow/ Green
Green Off LAN port’s 100Mbps link is inactive.
1-5