Installation Guide

- 13 -
Installation
STEP 1:
Attach the gasket
① to the housing ③
STEP 2:
Insert the cable (e.g., CAT5e) through the clamp ring ④, screw nut ②,
seal ⑤ and housing ③, as follows:
STEP 3:
Crimp the modular RJ plug to the cable. Note that the use of a snagless
cover shield or a strain-relief boot is not recommended here. After you
have crimped the cable, assemble the seal and the housing (③ and ⑤)
as indicated below:
STEP 4:
Tightly screw on the clamp ring
④ to
the housing and check to make sure
that the plug is securely fastened.
NOTE
For a tighter connection, you can
connect the RJ45 plug to the
AWK-4252A before STEP 4.