Installation Guide

- 14 -
LED Indicators
The front panel of the AWK-4252A contains several LED indicators. The
function of each LED is described in the table below:
LED
Color
State
Description
Front Panel LED Indicators (System)
PWR1 Green
On
Power is being supplied from power
input 1, 2, or PoE.
Off
Power is not being supplied.
LAN2
Green
On
LAN port’s 1000 Mbps link is active.
Blinking
Data is being transmitted at 1000 Mbps.
Off
LAN port’s 1000 Mbps link is inactive.
Amber
On
LAN port’s 100 Mbps link is active.
Blinking
Data is being transmitted at 100 Mbps.
Off
LAN port’s 100 Mbps link is inactive.
LAN1
Green
On
LAN port’s 1000 Mbps link is active.
Blinking
Data is being transmitted at 1000 Mbps.
Off
LAN port’s 1000 Mbps link is inactive.
Amber
On
LAN port’s 100 Mbps link is active.
Blinking
Data is being transmitted at 100 Mbps.
Off
LAN port’s 100 Mbps link is inactive.
2.4G
Green
On
Device is in Client/Client-Router/Slave
mode and has established a Wi-Fi
connection to an AP with a SNR value of
35 or higher.
Blinking
Data is being transmitted over the 2.4
GHz band.
Amber
On
Device is in
Client/Client-Router/Slave
mode and
has established a Wi-Fi
connection to an AP with a SNR value of
less than 35.
Blinking
Data is being transmitted over the 2.4
GHz band.
5G
Green
On
Device is in Client/Client-Router/Slave
mode and has established a Wi-Fi
connection to an AP with a SNR value of
35 or higher.
Blinking
Data is being transmitted over the 5 GHz
band.
Amber
On
Device is in
Client/Client-Router/Slave
mode and
has established a Wi-Fi
connection to an AP with a SNR
value of
less than 35.
Blinking
Data is being transmitted over the
5
GHz
band.
SYS
Red
On
System configuration error.
Blinking
System is booting up.
Green
On
System startup
completed and is
operating normally.
Blinking
Device has been located by the Wireless
Utility (interval: 1s).