Installation Guide

- 25 -
Radio Transmitters (Part 15)
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
IMPORTANT NOTE
This device is restricted to mobile configuration. To comply with FCC RF
exposure compliance requirements, the antenna used for this
transmitter must be installed to provide a separation distance of at
least 50 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter. This device must not
be co-located or operating in conjunction with any other antenna or
transmitter.
Canada, Innovation, Science and Economic Development Canada
(ISED) Notices
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two
conditions:
This device may not cause interference.
This device must accept any interference, including interference that
may cause undesired operation of the device.
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below the
Innovation, Science and Economic Development Canada (ISED) radio
frequency exposure limits. The Wireless Device should be used in such
a manner such that the potential for human contact during normal
operation is minimized.
This device has also been evaluated and shown compliant with the ISED
RF Exposure limits under mobile exposure conditions. (antennas are
greater than 50 cm from a person's body).
Avis du Canada, Innovation, Sciences et Développement
économique Canada (ISED)
L’émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le
fonctionnement.
Informations concernant l'exposition aux fréquences radio (RF)
La puissance de sortie rayonnée du dispositif sans fil est inférieure aux
limites d'exposition aux radiofréquences d'Innovation, Sciences et
Développement économique Canada (ISED). Le dispositif sans fil doit
être utilisé de manière à minimiser le potentiel de contact humain
pendant le fonctionnement normal.