User's Manual

AirWorks AWK-3121 User’s Manual Introduction
Functional Design
LED Indicators
The LEDs on the front panel of AWK-3121 allow you to identity the status and wireless settings
quickly.
The LED for FAULT indicates the system failure and
user-configured events. If the AWK-3121
cannot retrieve the IP address from a DHCP server, the FAULT LED will blink at an interval of
one second.
The LEDs for SIGNAL are a signal strength indicator and they merely function in Client mode.
The following table is a summary for the wireless settings and LED displays. You can check the
status of the AWK-3121 by reading these LEDs. More information about “Basic Wireless
Settings” is presented in Chapter 3.
Basic Wireless Settings LEDs
Operation mode WDS CLIENT BRIDGE SIGNAL
Note
AP Disable off off - AP mode
AP Enable off
on
- Bridge mode: WDS is enabled
Client -
on
off 0 Client mode: no association
Client -
on
off 1
Client mode: associated, but poor
signal
Client -
on
off 2-5
Client mode: associated; signal is
fine
1-5