EDS-205 Quick Installation Guide Moxa EtherDevice Switch Edition 7.1, March 2018 Technical Support Contact Information www.moxa.
Overview The Moxa, EDS-205 series EtherDevice™ switches are entry-level 5- port Ethernet switches that provide a cost-effective solution for your industrial Ethernet connection. The EDS-205 Series supports DC power input from 12 to 48 V. These switches can operate from -10 to 60oC, and the rugged hardware design makes the EDS-205 switches perfect for ensuring that your Ethernet equipment can be used for demanding industrial applications.
Panel Layout of the EDS-205 Series 1. 2. 3. 4. 5. 6. 7. 8.
Mounting Dimensions (unit = mm) -4-
DIN-Rail Mounting The plastic DIN-rail attachment plate should already be fixed to the rear panel of the EDS when you take it out of the box. If you need to reattach the DIN-rail attachment plate, make sure the DIN-rail kit is situated towards the top, as shown in the figures below. STEP 1: Insert the top of the DIN rail into the slot. STEP 2: The DIN-rail attachment unit will snap into place as shown below.
Wiring Requirements ATTENTION Safety First! Be sure to disconnect the power cord before installing and/or wiring your Moxa EtherDevice Switch. Calculate the maximum possible current in each power wire and common wire. Observe all electrical codes dictating the maximum current allowable for each wire size. If the current goes above the maximum ratings, the wiring could overheat, causing serious damage to your equipment.
Wiring the Power Inputs The two left-most contacts of the 3-contact terminal block connector on the EDS’s top panel are used for the DC input. Top and front views of one of the terminal block connectors are shown here. STEP 1: Insert the negative/positive DC wires into the V-/V+ terminals. STEP 2: To keep the DC wires from pulling loose, use a small flat-blade screwdriver to tighten the wire-clamp screws on the front of the terminal block connector.
RJ45 (8-pin) to RJ45 (8-pin) Straight-Through Cable Wiring RJ45 (8-pin) to RJ45 (8-pin) Cross-Over Cable Wiring LED Indicators The front panel of the Moxa EtherDevice Switch contains several LED indicators. The function of each LED is described in the table below. LED Color State Description Power is being supplied to the power input. Power is not being supplied to the Off power input. On The TP port’s 10 Mbps link is active. Blinking Data is being transmitted at 10 Mbps.
Switching, Filtering, and Forwarding Each time a packet arrives at one of the switched ports, a decision is made to either filter or forward the packet. Packets with source and destination addresses belonging to the same port segment will be filtered, constraining those packets to one port, and relieving the rest of the network from the need to process them.
Power Input Voltage Input Current Power Consumption Connection Overload Current Protection Reverse Polarity Protection Mechanical Casing Dimensions Weight Installation Environmental Limits Operating Temperature Storage Temperature Ambient Relative Humidity Regulatory Approvals Safety EMI EMS Shock Freefall Vibration WARRANTY Time Period Details 12 to 48 VDC 0.12 A @ 24 V 5W Removable 3-contact terminal block 1.
