User Manual

- 5 -
Mounting Dimensions (unit = mm)
DIN-Rail Mounting
The plastic DIN-Rail attachment plate should already be fixed to the
rear panel of EDS-208 when you take it out of the box. If you need to
reattach the DIN-Rail attachment plate to EDS-208, make sure the
DIN-Rail kit is situated towards the top, as shown in the figures below.
STEP 1:
Insert the top of the DIN
-Rail into
the slot.
STEP 2:
The DIN
-Rail attachment unit will
snap into place as shown below.
To remove Moxa EDS-208 from
the DIN
-Rail, insert a flat-blade
screw driver horizontally into the
DIN
-Rail kit under the EDS-208,
and then pull it upwards and
release EDS
-208 towards you
away from the DIN
-Rail.