User Manual

- 6 -

You may also take the following steps to remove the EDS-208 from the

DIN-Rail.

STEP 1:

ress the middle of the flat side of

the mounting kit as indicated

. Pull

the EDS

-208 downwards.

STEP 2:

elease it towards you and away

from the DIN

-Rail.

Wiring Requirements

ATTENTION

Safety First!

Be sure to disconnect the power cord before installing and/or

wiring your EDS

-208.

Calculate the maximum possible current in each power wire and

common

wire. Observe all electrical codes dictating the

maximum current allowable for each wire size.

If the current goes above the maximum ratings, the wiring

could overheat, causing serious damage to your equipment.

You should also pay attention to the following items:

• Use separate paths to route wiring for power and devices. If power

wiring and device wiring paths must cross, make sure the wires are

perpendicular at the intersection point.

NOTE: Do not run signal or communications wiring and power

wiring in the same wire conduit. To avoid interference, wires with

different signal characteristics should be routed separately.

• You can use the type of signal transmitted through a wire to

determine which wires should be kept separate. The rule of thumb

is that wiring that shares similar electrical characteristics can be

bundled together.

• Keep input wiring and output wiring separated.

• It is strongly advised that you label wiring to all devices in the

system when necessary.