User Manual

- 14 -
LED
Color
State
Description
PWR1 AMBER
On
Power is being supplied to power input PWR1
Off
Power is
not
being supplied to power input
PWR1
PWR2 AMBER
On
Power is being supplied to power input PWR2
Off
Power is not being supplied to power input
PWR2
FAULT RED
On
When the corresponding PORT alarm is
enabled, and the port’s link is inactive.
Off
When the corresponding PORT alarm is
enabled and the port’
s link is active, or when
the corresponding PORT alarm is disabled.
10M GREEN
On
TP port’s 10 Mbps link is active
Blinking
Data is being transmitted at 10 Mbps
Off
TP Port’s 10 Mbps link is inactive
100M
(TP)
GREEN
On
TP port’s 100 Mbps link is active
Blinking
Data is being transmitted at 100 Mbps
Off
100BaseTX Port’s link is inactive
100M
(FX)
GREEN
On
FX port’s 100 Mbps is active
Blinking
Data is being transmitted at 100 Mbps
Off
100BaseFX port is inactive
Auto MDI/MDI-X Connection
The Auto MDI/MDI-X function allows users to connect EDS-316’s
10/100BaseTX ports to any kind of Ethernet device, without needing to
pay attention to the type of Ethernet cable being used for the connection.
This means that you can use either a straight-through cable or cross-over
cable to connect EDS-316 to Ethernet devices.
Fiber Ports
Moxa EDS-316’s fiber switched ports operate at a fixed 100 Mbps speed
and full-duplex mode to provide the best performance. The fiber ports are
factory-built as either a multi-mode or single-mode SC/ST connector.
Consequently, you should use fiber cables that have SC/ST connectors at
both ends. When plugging the connector into the port, make sure the
slider guide is positioned to the right side so that it fits snuggly into the
port.