Installation Guide

- 12 -
STEP 1 : I nsert t he negative
(ground) / posit ive DI wires int o th e
┴
/ I t erm inals, respect ively.
STEP 2 :
To keep the DI wires from
pulling loose, use a sm all flat
-blade
scr ewdriver t o tight en t he w i
re- clam p
but t on
on t he front of t he ter m inal
block connect or .
STEP 3 :
I nser t t he plast ic term inal
block connect or pron gs int o t he
ter m inal block recept or, w hich is
locat ed on t he EDS devices’ r ight side.
Rot a t ing t h e Pow er Module
The power m odule for t he EDS device can be rot at ed t o m ake it easier
to fit y our field site applicat ion.
St ep 1 :
Rem ove
the t w o screws t hat fast en t he pow er m odule to t he
EDS device
.
St ep 2 :
Rem ove the power m odule.
St ep 3 :
Turn the power m odule clockw ise so that t he power , digit al
input , and relay out put connect ors can be m oved u pw ar ds.
St ep 4 :
P
lace t he m odule back on t o t he EDS device and t hen fast en
the
t w o scr ew s on to t he m odule.
Com m unica t ion Connect ion s
Each EDS- 4008 Series sw it ch has v arious t ypes of com m unicat ion
port s:
• RJ45 console port ( RS-232 int erface)
• USB st orage port ( t ype A connect or, curr ent ly disabled)
• m icroSD car d slot ( curr ent ly disabled)
• 10/ 100BaseTX Ether net ports
• 100BaseFX (SC/ ST- t ype connect or ) fiber p ort s
• 10/ 100/ 1000BaseT( X) Et hernet port s
• 100/ 1000BaseSFP por ts
Con sole Port Con n e ct ion
The EDS device has one RJ45 console port ( RS-23 2), locat ed on t he
front panel. Use eit her an RJ45- t o- DB9 ( see t he cable follow ing wiring
diagr am s) t o connect t he EDS’s console por t t o your PC’s COM port .
You m ay t hen use a console ter m inal program , such as Moxa PCom m
Ter m inal Em ulat or , t o access t he EDS that has a baud rat e of 115200.