Installation Guide

- 9 -
N OTE
Do not run signal or com m unications w iring an d power w iring
thr ough t he sam e w ire conduit . To avoid inter ference, w ires
with different signal char act erist ics should be rout ed separ ately.
• You can use t he t ype of signal tr ansm it t ed t hrough a w ire t o
det erm ine which wires should be k ept separate. The rule of t hum b
is t hat wir ing t hat shares sim ilar elect rical charact erist ics can be
bundled t oget her.
• You should separat e input w iring from out put wiring.
• We advise t hat you label t he w iring to all devices in y our syst em .
Gr ounding t he M oxa ED S Se ries
Grounding and wire rout ing help lim it t he effect s of noise due t o
electr om agnet ic int erference (EMI ). Run the ground connect ion from
the ground screw t o t he grounding surface pr ior t o connecting devices.
ATTEN TI ON
This product is int ended t o be m ount ed t o a well
-gr ounded
m ounting surface such as a met al panel.
Sug ge st ed W ire Type f or W ir ing Relay Con t a ct
( RELAY) , Digit a l I nput ( D I ) , a nd Pow e r I nput s
( P1 / P2 )
The EDS device includes t wo 4-pins 3.5 m m pin-pit ch t erm inal block s.
When w iring t he r elay cont act ( RELAY), digit al input (DI ) , and power
input s ( P1/ P2) , w e suggest using t he cable t ype – AWG 18- 24 and the
cor responding pin t ype cable t er m inals.
N OTE
The wir e m ust be able to withst and at least 105 ° C and t he
torque value should be 4.5 lb- in ( 0.51 N- m ) .