User`s manual

EDS-P510 Series Featured Functions
3-12
NOTE The four DIP Switches are used to configure both the “Turbo Ring” and “Turbo Ring V2” protocols, depending
on which protocol is active. To select which protocol the EDS will use, start the user interface software, and
then use the left menu to navigate to the Communication Redundancy page. To use one of the Turbo Ring
protocols for the EDS, select either “Turbo Ring” or “Turbo Ring V2” in the Redundancy Protocol drop-down
box.See the Configuring “Turbo Ring” and “Turbo Ring V2” section in this chapter for details.
The following tables show how to use the DIP switches to configure the EDS for “Turbo Ring” or “Turbo Ring
V2”.
NOTE DIP switch 4 must be set to the ON position to enable DIP switches 1, 2, and 3. If DIP switch 4 is set to the
“OFF” position, then DIP switches 1, 2, and 3 will all be disabled.
“Turbo Ring” DIP Switch Settings
DIP 1 DIP 2 DIP 3 DIP 4
ON: Enables this EDS as
the Ring Master.
ON: Enables the default
“Ring Coupling” ports.
ON: Activates DIP switches 1, 2, 3
to configure “Turbo Ring” settings.
Reserved for
future use.
OFF
: This EDS will not be
the Ring Master.
OFF: Do not use this EDS as
the ring coupler.
OFF: DIP switches 1, 2, 3 will be
disabled.
“Turbo Ring” V2 DIP Switch Settings
DIP 1 DIP 2 DIP 3 DIP 4
ON: Enables the default
“Ring Coupling (backup)”
port.
ON: Enables this EDS as
the Ring Master.
ON: Enables the default
“Ring Coupling” port.
ON: Activates DIP
switches 1, 2, 3 to
configure “Turbo Ring V2”
settings.
OFF: Enables the default
“Ring Coupling (primary)”
port.
OFF: This EDS will not be
the Ring Master.
OFF: Do not use this EDS
as a ring coupler.
OFF: DIP switches 1, 2, 3
will be disabled.
NOTE The DIP 1 setting will only be active if DIP 3 is in the ON position. If you set DIP 3 to OFF, then the default Ring
Coupling port will NOT be enabled, even if DIP 1 is ON.
Protocol Default Turbo Ring Ports Default Ring Coupling Port(s)
Turbo Ring ports G2 and G3 Ring Coupling Port = G1
Coupling Control Port=7
Turbo Ring V2 ports G2 and G3 Ring Coupling Port(Primary Port) =G1
Ring Coupling Port(BackUp Port) =G1
NOTE The Turbo Ring Ports and Coupling Ports will be added automatically to all VLANs if you set DIP Switch 4 to the
“ON” position.
NOTE If you do not enable any of the EDS-P510 switches to be the Ring Master, the Turbo Ring protocol will
automatically choose the EDS-P510 with the smallest MAC address range to be the Ring Master. If you
accidentally enable more than one EDS-P510 to be the Ring Master, these EDS-P510 switches will
auto-negotiate to determine which one will be the Ring Master.
NOTE If you use the browser interface to enable the DIP switches (by un-checking the “Disable the Turbo Ring DIP
switch” checkbox), and then flip DIP switch 4 from ON to OFF, the Ring Ports and Coupling Ports that were
added to all VLANs will be restored to their previous software settings. (For details, please refer to the “Using
Virtual LANs” section of this manual).