User`s manual

EDS-P510 Series Featured Functions
3-30
Redundant Ports
Setting Description Factory Default
1st Port Select any port of the EDS to be one of the redundant ports. port G2
2nd Port Select any port of the EDS to be one of the redundant ports. port G3
Enable Ring Coupling
Setting Description Factory Default
Enable Select this EDS as Coupler
Disable Do not select this EDS as Coupler
Not checked
Coupling Port
Setting Description Factory Default
Coupling Port Select any port of the EDS to be the coupling port port 7
Coupling Control Port
Setting Description Factory Default
Coupling Control Port Select any port of the EDS to be the coupling control port port G1
Configuring “Turbo Ring V2”
NOTE When using the Dual-Ring architecture, users must configure settings for both Ring 1 and Ring 2. In this case,
the status of both rings will appear under “Current Status.”
Explanation of “Current Status” Items
Now Active
Shows which communication protocol is in use: Turbo Ring, Turbo Ring V2, RSTP, or none.
Ring 1/2—Status
Shows Healthy if the ring is operating normally, and shows Break if the ring’s backup link is active.
Ring 1/2—Master/Slave
Indicates whether or not this EDS is the Master of the Turbo Ring. (This field appears only when selected to
operate in Turbo Ring or Turbo Ring V2 mode.)
NOTE The user does not need to set the master to use Turbo Ring. If no master is set, the Turbo Ring protocol will
assign master status to one of the EDS units in the ring. The master is only used to determine which segment
serves as the backup path.