User`s manual

EDS-P510 Series Featured Functions
3-64
Mail Server IP/Name
Setting Description Factory Default
IP address The IP Address of your email server. None
Account Name
Setting Description Factory Default
Max. 45 Characters Your email account name (typically your user name) None
Password Setting
Setting Description Factory Default
Disable/Enable to
change Password
To reset the Password from the Web Browser interface, click
the Change password check-box, type the Old Password, type
the New Password, retype the New password, and then click
Activate; Max. 45 Characters.
Disable
Old Password Type the current password when changing the password None
New Password Type new password when enabled to change password; Max.
45 Characters.
None
Retype Password If you type a new password in the Password field, you will be
required to retype the password in the Retype new password
field before updating the new password.
None
Email Address
Setting Description Factory Default
Max. 30 characters You can set up to 4 email addresses to receive alarm emails
from the EDS-P510.
None
Send Test Email
After configuring the email settings, you should first click Activate to activate those settings, and then click
Send Test Email to verify that the settings are correct.
NOTE Auto warning e-mail messages will be sent through an authentication protected SMTP server that supports
the CRAM-MD5, LOGIN, and PLAIN methods of SASL (Simple Authentication and Security Layer)
authentication mechanism.
We strongly recommend not entering your Account Name and Account Password if auto warning e-mail
messages can be delivered without using an authentication mechanism.
Configuring Relay Warning
The Auto Relay Warning function uses relay output to alert the user when certain user-configured events take
place. There are two basic steps required to set up the Relay Warning function:
1. Configuring Relay Event Types
Select the desired Event types from the Console or Web Browser Event type page (a description of each
event type is given later in the Relay Alarm Events setting subsection).
2. Activate your settings
After completing the configuration procedure, you will need to activate your EDS-P510’s Relay Event Types.