User`s manual

EDS-P510 Series Featured Functions
3-66
Warning List
Use this table to see if any relay alarms have been issued.
Using Line-Swap-Fast-Recovery
The Line-Swap Fast Recovery function, which is enabled by default, allows the EDS-P510 to return to normal
operation extremely quickly after devices are unplugged and then re-plugged into different ports. The recovery
time is on the order of a few milliseconds (compare this with standard commercial switches for which the
recovery time could be on the order of several minutes). To disable the Line-Swap Fast Recovery function, or
to re-enable the function after it has already been disabled, access either the Console utility’s Line-Swap
recovery page, or the Web Browser interface’s Line-Swap fast recovery page, as the following figure
shows:
Configuring Line-Swap Fast Recovery
Enable Line-Swap-Fast-Recovery
Setting Description Factory Default
Enable/Disable Select this option to enable the Line-Swap-Fast-Recovery
function
Enable
Using Set Device IP
To reduce the effort required to set up IP addresses, the EDS-P510 series comes equipped with DHCP/BOOTP
server and RARP protocol to set up IP addresses of Ethernet-enabled devices automatically.
When enabled, the Set device IP function allows the EDS-P510 to assign specific IP addresses automatically
to connected devices that are equIPped with DHCP Client or RARP protocol. In effect, the EDS-P510 acts as a
DHCP server by assigning a connected device with a specific IP address stored in its internal memory. Each time
the connected device is switched on or rebooted, the EDS-P510 sends the device the desired IP address.
Perform the following steps to use the Set device IP function: