User`s manual

IA260 WinCE User’s Manual Getting Started
Powering on the IA260
To boot up the system, connect the power source to the power input located on the computer’s top
panel. It takes about 5 seconds for the system to boot up. You will hear a clear “BEEP” sound
when the boot up procedure is finished. Once the system is ready, the “Ready” LED will light up
and stay on until you shut down the computer.
Resetting the IA260-CE Computer
Warm-Start: When powering on, push the “Reset” button briefly (for less than1 second). The
computer will reboot automatically.
Cold-Start: Switch the power off and then on again. The computer will reboot automatically.
Reset to Factory Defaults (Configuration only): If the computer is not working properly and
you would like to reset it to factory default settings, press and hold the “Reset” button for 5
seconds as the operating system is starting up. The buzzer sounds while the factory default settings
are being loaded. After the factory default settings have finished loading, the computer will reboot
automatically. Do not confuse this action with “Warm-Start.”
Reset to Factory Defaults (Configuration and file system): If the computer will not start up, you
must go to the Boot Loader and format the flash storage. Once the flash storage has been
reformatted, restart the computer.
Rebooting the IA260-CE Computer
While the computer is powering on, click the “start” button and select “Reboot.” The computer
will reboot automatically.
2-2