User Manual

Moxa’s Managed Switch Next Generation OS (v3.x) User Manual
64
Setting
Description
Factory Default
Force
Provides power output to non-802.3 af/at/bt PDs when the
detected PD has higher/lower resistance or higher capacitance
and the acceptable PD resistance range exceeds 2.4 kΩ. The
system will prompt you to select Force Mode to allocate 0 to
90 watts of power.
Legacy PD Detection
The PoE Ethernet Switch includes a Legacy PD Detection function. When the capacitance of the PD is higher
than 2.7 μF and less than 10 μF, enabling the Legacy PD Detection will trigger the system to output power
to the PD. In this case, it will take a few seconds for PoE power to be output through this port after the
switch Legacy PD Detection is enabled.
Setting
Description
Factory Default
Enable
Enable legacy PD detection.
Disabled
Disable
Disable legacy PD detection.
Power Allocation (watt)
Setting
Description
Factory Default
0 to 90
Input the power allocation value.
0
Priority
Use Power Priority when managing PoE power with measured power mode. You can choose one of the
following settings: critical, high, or low. When the PoE measured power exceeds the assigned limit, the
switch will disable the PoE port with the lowest priority.
Setting
Description
Factory Default
Critical
Configure the port as critical (highest) priority.
Low
High
Configure the port as high priority.
Low
Configure the port as low priority.
Copy Config to Ports
Setting
Description
Factory Default
Select the port(s) from
the drop-down list
Allows you to copy the configurations to other port(s). None
When finished, click APPLY to save your changes.
PD Failure Check
The PoE Ethernet switch can monitor the status of a PD via its IP address. If the PD fails, the switch will not
receive a PD response after the defined period, and the authentication process will be restarted. This
function is extremely useful for ensuring your network’s reliability and reducing your management burden.
Select the PD Failure Check tab, and then click the edit icon on the port you want to configure.