User Manual

Moxa’s Managed Switch Next Generation OS (v3.x) User Manual
70
Device Type
Item
Description
Not Present
No connection to the port.
Legacy PoE Device
A legacy PD is connected to the port, and the PD has detected that the
voltage is too low or high, or the PD’s detected capacitance is too
high.
802.3bt DS
An IEEE 802.3bt Dual Signature PD is connected to the port.
802.3bt SS
An IEEE 802.3bt Single Signature PD is connected to the port.
NIC
A NIC is connected to the port.
Unknown
An unknown PD is connected to the port.
N/A
The PoE function is disabled.
Configuration Suggestion
Item
Description
Disable PoE power output
When detecting a NIC or unknown PD, the system suggests disabling
PoE power output.
Enable “Legacy PD Detection”
When detecting a higher capacitance of PD, the system suggests
enabling Legacy PD Detection.
Select Force Mode
When detecting higher/lower resistance or higher capacitance, the
system suggests selecting Force Mode.
Select IEEE 802.3bt auto mode
When detecting an IEEE 802.3bt PD, the system suggests selecting
802.3bt Auto mode.
Select high power output
When detecting an unknown classification, the system suggests
selecting High Power output.
Raise the external power supply
voltage to greater than 46 VDC
When the external supply voltage is detected at less than 46 V, the
system suggests raising the voltage.
Enable PoE function for detection
The system suggests enabling the PoE function.
Layer 2 Switching
This section describes how to configure various parameters, such as VLAN, GARP, MAC, QoS, and
Multicast, for Moxa’s switch. Click Layer 2 Switching on the function menu.
VLAN
This section includes IEEE802.1Q configurations.