User Manual

Moxa’s Managed Switch Next Generation OS (v3.x) User Manual
8
Configuration Reminders
In this section, several examples will be used to remind users when configuring the settings for Moxa’s
switch.
A: About Mandatory Parameters
1. The items with asterisks mean they are mandatory parameters that must be provided. In the figure
above, the parameters for VLAN, Version, and Query Interval all need to be provided, or it will not be
created or applied.
2. If the item is marked with red it means this item has been skipped. You need to fill in the parameters or
you cannot apply or create the function.
In addition, some parameter values will be limited to a specific range. If the values exceed the range, it
cannot be applied or created.
B: Configurations before Enable/Disable
In another situation, some settings can be configured first, but remain disabled. Users can decide to enable
them when necessary without configuring the same settings again. This is particularly convenient and user-
friendly when configuring various settings. For example, on the DHCP Server configuration page, users can
configure the DHCP settings first, but later select to disable the DHCP settings in the General tab. When
users decide to enable the DHCP settings, they only need to select Enable in General settings, so that the
DHCP settings (either MAC-based IP Assignment or Port-based IP Assignment as shown as an
example in the following figure) can be enabled at the same time.