User Manual

Moxa’s Managed Switch Next Generation OS (v3.x) User Manual
98
STP/RSTP Settings and Status
This section describes how to configure Spanning Tree settings.
General
Click Spanning Tree on the menu and then select the General tab.
Configure the following settings.
STP Mode
Setting
Description
Factory Default
Disabled
Disable Spanning Tree.
Disabled
STP/RSTP
Specify STP/RSTP as the STP mode.
MSTP
Specify MSTP as the STP mode.
Click APPLY to save your changes. When STP/RSTP has been selected, configure the following settings.
STP Mode
Setting
Description
Factory Default
STP/RSTP
Use the STP/RSTP mode as the Spanning Tree protocol.
STP/RSTP
Compatibility
Setting
Description
Factory Default
STP
To be compatible with STP mode only
RSTP
RSTP
To be compatible with RSTP and STP modes
Bridge Priority
Setting
Description
Factory Default
0 to 61440
Increase this device’s bridge priority by selecting a lower
number. A device with a higher bridge priority has a greater
chance of being established as the root of the Spanning Tree
topology.
32768
Forwarding Delay Time (sec.)
Setting
Description
Factory Default
4 to 30
The amount of time the device waits before checking to see if
it should change to a different state.
15