NPort 6450 Series Quick Installation Guide Edition 10.0, November 2017 Technical Support Contact Information www.moxa.
Overview The NPort 6450 secure serial device servers provide reliable serial-to-Ethernet connectivity for a wide range of serial devices. The NPort 6450 supports TCP Server, TCP Client, UDP, and Pair-Connection operation modes to ensure the compatibility of network software. In addition, the NPort 6450 also supports Secure TCP Server, Secure TCP Client, Secure Pair-Connection, and Secure Real COM modes for security critical applications such as banking, telecom, access control, and remote site management.
Hardware Introduction NOTE The LCD panel is only available with standard temperature models. Reset Button—Press the Reset button continuously for 5 sec to load factory defaults. Use a pointed object, such as a straightened paper clip or toothpick, to press the reset button. This will cause the Ready LED to blink on and off. The factory defaults will be loaded once the Ready LED stops blinking (after about 5 seconds). At this point, you should release the reset button.
Name FX Color Orange Alarm Red Off Module Green Off Function Steady on: Blinking: Ethernet port is idle. Fiber port is transmitting or receiving data. The relay output (DOUT) is open (exception). The relay output (DOUT) is shorted (normal condition). A network module has been detected. No network module is present. Adjustable pull up/down resistor for RS-422/485 (150 KΩ or 1 KΩ) Jumpers are used to set the pull up/down resistors. The default is 150 KΩ. Short the jumpers to set this value to 1 KΩ.
Software Installation Information The Document & Software CD contains the User’s Manual, NPort Search Utility, and the PComm Lite Suite. Insert the CD and follow the on-screen instructions. Please refer to the User’s Manual for additional details on using the NPort Search Utility and PComm Lite.
