Installation Guide

- 2 -
Overview
The NPort W2150A-W4/W2250A-W4 wireless device servers are an
ideal choice for connecting serial devices or Ethernet devices, including
PLCs, meters, and sensors, to an IP-based wireless LAN or Ethernet
LAN.
Features
• Links serial and Ethernet devices to an IEEE 802.11a/b/g/n network
• Web-based configuration using built-in Ethernet or WLAN
• Secure boot for Moxa-only allowed firmware allowed to run
• Remote configuration with HTTPS, SSH
• Secure data access with WEP, WPA, WPA2
• Fast roaming for quick automatic switching between access points
• Offline port buffering and serial data log
• Enhanced surge protection for serial, LAN, and power
• Dual power inputs (1 screw-type power jack, 1 terminal block)
Package Checklist
Before installing the NPort W2150A/W2250A-W4 device server, verify
that the package contains the following items:
• 1 NPort W2150A-W4 or NPort W2250A-W4 wireless device server.
• 1 antenna 2.4/5GHz: ANT-WDB-ASM-03 BK.
• 100 to 240 VAC power adapter. (excluding T models)*
• 1 Ethernet cable: CBL-RJ458P-100.
• Quick installation guide (printed).
• Warranty card.
NOTE
The power adapter is suitable for your region.
Optional Accessories
• DK35A (35 mm DIN-rail mounting kit; 4 screws included).
• CBL-PJ21NOPEN-BK-30: Locking barrel plug to bare-wires cable.
• Mini DB9F-to-TB: DB9-female-to-terminal-block adapter for RS-
422/485 applications.
NOTE
Notify your sales representative if any of the above items are
missing or damaged.
ATTENTION
To comply with FCC
RF exposure compliance requirements, the
antenna used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must
not be co
-located or operating in conjunction with any other
antenna or transmitter.