User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- 3. Initial IP Address Configuration
- 4. Web Console Configuration
- 5. System Management Settings
- 6. Introduction and Configuring VPN
- 7. Configuring OnCell Central Management Software
- 8. OnCell Search Utility
- A. Default Settings
- B. Dynamic Domain Name Server
- C. Auto IP Report Protocol
OnCell 5000 Series Initial IP Address Configuration
3-7
6. If the OnCell 5000 has been set up for password protection, you will be prompted to enter the password.
After you enter the password, or if password protection was not enabled, you will be prompted to select the
terminal mode. Press 1 for ansi/vt100 and then press ENTER.
7. The main menu should appear. Once you are in the console, you may configure the IP address through the
Network menu, just as with the Telnet console. Refer to steps 4 to 11 in the Telnet Console section to
complete the initial IP configuration.