User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- 3. Initial IP Address Configuration
- 4. Web Console Configuration
- 5. System Management Settings
- 6. Introduction and Configuring VPN
- 7. Configuring OnCell Central Management Software
- 8. OnCell Search Utility
- A. Default Settings
- B. Dynamic Domain Name Server
- C. Auto IP Report Protocol
OnCell 5000 Series System Management Settings
5-8
Load Factory Defaults
This function will reset all of the OnCell 5000’s settings to the factory default values. All previous settings,
including the console password will be lost. If you wish to keep the OnCell 5000 IP address, netmask, and other
IP settings, make sure Keep IP settings is checked before loading the factory defaults.
Change Password
For all changes to the OnCell 5000’s password protection settings, you will first need to enter the old password.
Leave this blank if you are setting up password protection for the first time. To set up a new password or change
the existing password, enter the password under both New password and Confirm password. To remove
password protection, leave the New password and Confirm password boxes blank.
ATTENTION
If you forget the password, the ONLY way to configure the OnCell 5000 is by using the reset button on the
OnCell 5000’s casing to load the factory defaults.
Before you set a password for the first time, it is a good idea to export the configuration to a file when you
have finished setting up your OnCell 5000. Your configuration can then be easily imported back into the
OnCell 5000 if you need to reset the OnCell 5000 due to a forgotten password or for other reasons. Please
refer to the section on Configuration Import/Export earlier in this chapter for more details.
Certificate
Ethernet SSL Certificate Import