User`s manual

OnCell 5000 Series Configuring OnCell Central Management Software
7-6
2. Click on Tool Æ Control Ports Settings to modify the port number.
To modify the new configuration of control ports, you can make all configuration changes here. The Control
Ports Setting’s information must match the web console’s OnCell Central Server Settings. Please refer to
Step 2, OnCell Device Web Console Settings, for control port information. Click Save if any modifications
have been made.
3. Click on Tool Æ User Ports Settings to modify the port number. Click Save if any modifications have been
made.
User Ports are used to connect the host and OnCell Central Server. The User Ports are assigned by the
OnCell Central Server to each OnCell device sequentially within the specified port range.
Data port: Ports used to communicate with serial devices connected to the OnCell.
Command port: The TCP port for listening to SSDK commands from the host.
Service forwarding: Ports used to communicate with Ethernet devices connected to the OnCell.
Telnet port: The telnet port is the TCP listening port that allows the host to configure the OnCell via Telnet.
NOTE: Enabling Remove registered ports will remove the already assigned port numbers within
the specified port range from the system.