User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- 3. Initial IP Address Configuration
- 4. Introducing Serial Port Operation Modes
- 5. Introducing OnCell Central and Ethernet Operation Modes
- 6. Using the Web Console
- 7. Cellular Network Settings
- 8. Configuring Serial Port Operation Modes
- 9. Configuring the Cellular-Enabling Ethernet Device
- 10. Configuring OnCell Central Management Software
- 11. Additional Serial Port Settings
- 12. System Management Settings
- 13. Software Installation/Configuration
- A. Pinouts and Cable Wiring
- B. RFC2217
- C. Dynamic Domain Name Server
- D. Well Known Port Numbers
- E. Auto IP Report Protocol
- F. GSM Alphabet
- G. Default Settings
OnCell G3111/G3151/G3211/G3251 Series User’s Manual Configuring OnCell Central Software
10-29
Note: If the data or command port is occupied, an error message will appear at the bottom of the
window.
Service Forwarding (not available with G3111/G3151/G3211/G3251)
Item
Description
Status
Show the status for User Service Port.
Closed: this mean the port is not connected
Registered: this mean the port is in the registering state
Connected: this mean the port is connected, and ready to use
Service Port
The port number is allowed host to establish the ethernet
connection to OnCell Central which is mapping to OnCell device
Protocol
Protocol type for Service forwarding connection
Device Name
Device’s Name
Device IP
Device’s IP address
Port
This is the local port number for Ethernet device
Description
Device’s more detailed description