User`s manual

OnCell G3111/G3151/G3211/G3251 Series User’s Manual Configuring OnCell Central Software
10-14
OnCell Central Server
Configuration
Server (default=Disable): If you select Enable, the OnCell will be ready to connect to the OnCell
Central Server
Server IP: Enter the IP address that will be assigned to your OnCell Central Server. The IP
address must be in the Public IP domain.
Auto reconnect period (default=10s): This field specifies the idle time setting for auto-reconnect.
Control Port
Management information port (default=63201): This port is used to transfer status information
of the OnCell to the OnCell Central Server. The port number must match the OnCell Central
Manager’s port number which install in the OnCell Central Server. In order to prevent port conflict
with other applications, the user can set the management information port to another port if
needed.
Management configuration port (default=63202): This port is used to transfer configurations
from the OnCell to the OnCell Central Server. The port number must match the OnCell Central
Manager’s port number which install in the OnCell Central Server. In order to prevent a port
conflict with other applications, the user can set the management information port to another port
if needed.
Telnet port (default=63203): The Telnet port is the TCP port that is listening for Telnet
connection from the host side. In order to prevent a TCP port conflict with other applications, the
user can set the Telnet port to another port if needed.
OP mode data port 1 (default=63211): This is the operation mode TCP port number assignment
for the serial port on the OnCell device. It is the port number that the serial port uses to listen for
connections. To avoid conflicts with well known TCP ports, the default is set to 63211.
OP mode cmd port 1 (default=63251): The operation mode command port is the TCP port for
listening to SSDK commands from the OnCell Central Server. In order to prevent a TCP port
conflict with other applications, the user can set the Command port to another port if needed.